Vertical stepping contour lines problem

Guest 2021-12-13 442

This little guy was printed on a Anycubic Photon SE. On close inspection you can see evenly spaced contour lines running vertically. I am not sure as a newbie to 3D printing if this is a Chitubox setting I can adjust in the settings? or a printer setting issue.

Attached is a screenshot of the STL and then the actual print.



Thanks.

Dave

New Post (1)
  • Guest 2021-12-15
    Quote 2Floor
    I believe this is a normal phenomenon. From the current point of view, all resin printed things will be like this, but some are obvious and some are not obvious. Adjusting the printing angle and anti-aliasing can improve this situation.