Hi, when slicing a single model centered on the plate, then everything works fine. What you see are the RAFT - Layers of the models.

But when i duplicate it i ALWAYS get the following bug (see below). In the bottom right corner (always bottom right) between slice 13 and 20 there is a missing "bar". The slices below look fine, and >= 20 they are ok too. But between 13 and 20 they are screwd. I completely do not know why. It can't be that i print outside the border because, the other slices work, and as you can see, there are pixels lighted beond the missing ones. Obviously also the software shows it as "Error" (green pane), so it knows, here is something not ok.

I have this problem in 1.5.0 and 1.6.3!