CHiTuBox makes vertukal holes

2020-2-5 1014

Since i have installed CHiTuBox 1.6.3 i have vertikal holes all around the buildplate, no matter i print only one part or 16 pieces at time.

See the photo of pieces of a chess board with vertikal holes.


Is tthis a bug in CHiTuBox-1.6.3 or is the LCD panel damaged ?


excuse the bad english


MfG


Hans-W. Haag

上传的附件:
New Post (3)
  • CHITUBOX 2020-2-8
    Quote 2Floor
    Hello, it is recommended to check whether there is a problem with the sliced picture. If not, it may be a problem with the resin setting or the machine itself.
  • 2020-2-8
    Quote 3Floor

    Thanks for the answer,

    but it was not the sliced picture and not the resin settings / eposure times.

    I found that the LCD-Paneel has grey circels on the mirrored backside ( see foto ), these circels make black holes on the LCD-Screen while printing. I tested this by printing for some seconds whitout the resin tank. So I disassembeld the LCD-Panel to make this foto for you.  What now ?

    Best regards

    Hans-W. Haag

    上传的附件:
  • CHITUBOX 2020-2-9
    Quote 4Floor
    Thanks for the answer,but it was not the sliced picture and not the resin settings / eposure times.I ...
    Hello, you'd better contact the printer supplier to confirm whether it is a screen problem.