Supports that connect from model to model.

Joseph Brophy 3 Months+ 309

I requested this before but I'm not sure I was understood. A fouth support option (like light, med and heavy), that allows you to connect two points of the model. I've provided a picture of what I can currently accomplish with your program that is similar. Issue is doing this is very hard and often crashes the program.

上传的附件:
New Post (2)
  • 3 Months+
    Quote 2Floor
    This is a very good suggestion, I have feedback to the R & D team.
    Thanks
  • Joseph Brophy 3 Months+
    Quote 3Floor
    Another plus is that it would give users the ability to preform minor resculpts to make near impossible models printable.