POssible to move up & down before layer and possible to not lift during start?

2020-8-11 1319

Hey guys, so i am trying to do crystal clear prints and having issues foring with micro bubbles, ive found manually going up and down with the Z axis agasint the fep can pop/ remove bubbles, I am wondering if there is a way (or to add in inter section gcode) a way that when it comes down to mask/cure its next layer it would come down, up down a few times but only by about 1mm or so before coming down to cure that layer?

Also when my nova3d starts the print, is it possible to start it submerged as if i start a print submerged it lifts up to home then coms back down which tends to bring air bubbles with it.

Thank you

New Post (0)