Question about G code section in Chitubox

Guest 2020-12-15 1162

Hello, I am new in Chitubox software and need some help. I am using Sonic Mini 4K. What I want to do is to add a pause of 30 sec. in the begining of printing. When I start the print job, the Z axis lower to the Z 0 position and I want to hold the build plate at this position for about 30 sec, before the exposition of the first layer. Is it possible to modify the G code to add the pause?

Thanks in advance.

New Post (1)
  • cbd 2020-12-17
    Quote 2Floor
    You can change the low-level light off delay to make it still before exposure