I am new in resin printing. Before I was only printing with PLA and PETG. IMy printer is a Creality LD-002R. I printed a model with a technical bakground. There are two 'springs' which should be not bonded to the main body over the full length. In the slicer I can see that the gap is present (please see attchements) but after printing and cleaning (not yet irradiated with uv light) this 'springs' are already bonded to the main body. Since I am pretty sure that I am doing something wrong (e.g. parameters) I would kindly ask you if you have a hint for me to optimize my prints.