Too thin walls when hollowing a small feature

2021-2-19 511

When a small part in a peice is hollowed, the perimeter there becomes way too thin, much less than specified, and the piece fail and break. This happens so that the 2 perimeters don't overlap, but they should be allowed to.


New Post (2)
  • cbd 2021-2-19
    Quote 2Floor
    hello,
    Can you send your model to support@chitubox.com for testing?
  • 2021-2-20
    Quote 3Floor
    cbd hello, Can you send your model to support@chitubox.com for testing?

    Hi, I sent it now.

    There is also another issue in the same project: After hollowing a part is created outside the model