2. Feature Requests
  3. lift height problem, when layer changes from bottom to normal.

lift height problem, when layer changes from bottom to normal.

2021-3-8 675

We can set bottom lift height and normal lift height indiviually.

because bottom layer stick strong at FEB film. 

So I set higer lift height for bottom. and i set less height for normal layer to save time.


but problem is when it changes from bottom layer to normal layer,

After last of bottom layer exposure, lift height should applyed bottom lift height, but it changes normal layer height.

It means, Last bottom layer is applyed normal lift height. so it causes printing problem.


May I have a solution for it? or update?
(I have a phrozen sonic mini 4k)


New Post (4)
  • Cliff Knight 2021-3-9
    Quote 2Floor
    What problem specifically?
  • cbd 2021-3-9
    Quote 3Floor
    Do you mean the lift height of the last layer of the ground floor is the lift height of the normal layer?
  • 2021-3-9
    Quote 4Floor

    example, when I print 2 bottom layers and 2 normal layers.

    1 step)
    bottom exposure
    bottom height lift up

    2 step)
    bottom exposure
    normal height lift up -> this problem.(not enough lift height for bottom layer)
    * I think this should be 'bottom height lift up'

    3 step)
    normal exposure
    normal height lift up

    4 step)
    normal exposure
    normal height lift up

  • Cliff Knight 2021-3-16
    Quote 5Floor
    A "work-around" would be to increment the number of "bottom" layers--logically creating a "faux bottom" layer.
    Then "bottom" layers 1 & 2 would have the configured bottom layer lifts, the faux bottom layer (3) would have the normal lift.