Update the model but keep supports

Guest 2021-6-6 1028

Suppose I spend an hour or whatever setting up my supports and print it, only to find that I need to make a small tweak to the model. Is there some way I can make the small adjustment, then load it in and use the old supports, without having to spend another hour doing them all over?

New Post (2)
  • Guest 2021-6-7
    Quote 2Floor

    It can be fine-tuned after the support is generated. You can take a look at the GIF below.

  • Guest 2021-9-13
    Quote 3Floor
    Yes I have the same question. After a few chances on the model put the old model out and put the new model in. And keep the "old" supports.
    Its not the question about fine tuning its a question abaout saving time by changing the model.