Hi,
anyone with a solution to this?
I sliced a model with Chitubox 1.9.5 and saved it with no special characters to the USB stick. It shows up nice in the filelist on the printer.
I even tried the filename "test.pm3m"
But when I start the print it only prints the first layer and then stucks. The printplate doesn't rise and stays in it position. Seems like a crash but I can stop the print on the printer display. What I found is that the printing time is way off on this model. Chitubox expects to print 18 hours but the printer shows abou 2 hours.
Anyone with a similar problem or a solution?
Thanks and cheers from Germany
Robert