On the latest version of Chitubox pro I have an issue where every STL or 3MF file I load in gets reported as damaged but if I do a repair of the file when it prints I get wierd artifacts protruding from the print or in the most bizzare cases half of the print id replicated and stuck to the side of the main print. I had a 2 headed dog on 1 print. If I dont repair it mainly prints OK but not always. If I print the same files in Halotbox I dont get any damaged file errors and the prints are perfect so the issue is definately with Chitubox Pro, does anyone else have this issue. I raised this with the Chitubox helpdesk but had no reply.