Slicer filling in holes

danie 2020-1-22 1042

Attached is a simple model that does not slice correctly. At 50 microns, layer 47 will be filled in.

And thank you for such a great piece of software, even if it has it's ocassional issues!

New Post (2)
  • CHITUBOX 2020-2-8
    Quote 2Floor
    Hello, we tested this model, optimized the slicing, and this problem has been solved. The next version can slice this model normally. However, this model also has some problems. The triangle is too small. Thank you very much for your feedback, thank you.
  • danie 2020-2-10
    Quote 3Floor
    Brilliant stuff. I look forward to the next version. 

    Just how small can triangles go?