Wrong slicing on big model-Troubleshooting and Bug Reports-CHITUBOX Community

Wrong slicing on big model

Guest 2020-2-8 974

Hello, using version 1.6.3 I found and interesting issue with a big model. Please look at the rendering of Chitubox and the actual printed part. As you can see, the entire right side was replaced by this slope... Any clue on what's going on here?

New Post (1)

CHITUBOX 2020-2-8

Quote 2Floor

Hello, this model is a bit large relative to the platform, it is best to print at an angle
(reducing abrupt crosssectional area changes). According to the printed results, the drawing force is too large, and the plane is damaged.
It is recommended that you use heavy supports while reducing the lifting speed.