Auto-Supported being generated on 90º hard angles

Brian Greenstone 5 Months+ 112

For some annoying reason Chitubot will consistently generate auto-supports right into the crease of hard angles like in this quick example I made:




I never have this problem with Lychee, but Chitutox does it every time, and it creates a lot of extra work for me to delete the bad ones and create new ones.  Obviously, if I printed them like this they would never snap off cleanly and would leave a mark on the sharp edge.

The problem mainly occurs when there is geometry above the crease that sticks out over it (as in the example there).



New Post (1)
  • cbd 5 Months+
    Quote 2Floor
    hello.
    We will optimize it in a future version.